Parameter 7 Action on Receipt of Break from Terminal
Parameter 7 is bit-mapped; binary bit values represent the following
actions when the break signal is received by the PAD.
Parameter 7 supports the following values:
Values 0-31
5 (Factory Setting) Send interrupt and indicate break
Parameter 7 supports the following bit values:
Bit Values Description
1 Send an X.25 interrupt packet to the remote system
2 Send an X.25 reset packet to the remote system
4 Send an X.25 indication of break packet to the remote system
8 Escape from the data transfer state to the PAD command state
16 Set PAD parameter 8 to 1 (discard output)
Note: If bit 2 of S53 is set, using the break signal to escape from
the data transfer state is not possible.
Note: Adding bit values provides multiple functionality, e.g., Set
7:17 would enter bits 1 and 16. Bits 1 and 16 enable an X.25 interrupt packet
to the remote system and discard the output.
Click here to return to the Contents page.