#BDR - Select Baud Rate (Turn off Autobaud)

This command forces the modem to select a specific DTE/modem baud rate without further speed sensing on the interface. When a valid #BDR=n command is entered, the OK result code is sent at the current assumed speed. After the OK has been sent, the modem switches to the speed indicated by the #BDR=n command it has just received.

When in Online Voice Command Mode and the #BDR setting is non zero (no autobaud selected), the modem supports a full duplex DTE interface. This means that the DTE can enter commands at any time, even if the modem is in the process of sending a shielded code indicating DTMF detection to the DTE.

When in Online Voice Command Mode and the #BDR setting is zero (autobaud selected), shielded code reporting to the DTE is disabled.

Note: When #BDR has been set at non zero, the modem employs the S30 Deadman Timer, and this timer starts at the point where #BDR is set at non zero. If this period expires (nominally 60 seconds) with on activity on the DTE interface, the modem reverts to #BDR=0 and #CLS=0.

Parameters:
n = 0 - 48 (New baud rate is n*2400bps)

Default:
0

Result Codes:
OK - If n = 0 - 48.

ERROR - Otherwise

Command Options:
#BDR? - Returns the current setting of the #BDR command as an ASCII decimal value in result code format.

#BDR=0 - Enables autobaud detection on the DTE interface.

#BDR=n - Where 1<n<48. Sends OK message at current speed, then switches to the new speed defined by n*2400 bps unless and until another #BDR=n command is received. Autobaud is disabled, and the character format is maintained at the format most recently detected.

Click here to return to the Contents page.